VIA Registration of Aluminum Wheel
ログイン 初めてご利用される方
Home Japanese Chinese
HomeQ&A >About Costs and Remittance
Q&A

About Costs and Remittance
Q26: What are the registration fees?
Q27: What are the fees for a certification inspection of testing equipment and facilities?
Q28: When applying to register a representative model, how much does it cost to add two insets at once for the same model?
Q29: After registering a representative model, can we register additional sizes for just the cost of the registration fee?

Q26: What are the registration fees?
A26: The rates vary depending on the contents of registration as follows:
(1) For application of registration by documentary judgment
 
A registration fee, documentary judgment fee, verification test fee and testing report fee will be necessary.

See the price table on the Council website.
*1:When a documentary judgment includes registration by category, a fee for registration by category will be added.
*2:When registering an assembly-type wheel, the class representative review fee is added if registering the wheel as a class representative.
*3:The verification test fee is charged for wheels that have been verification tested. The test report fee must be paid if you want a test report issued after the verification test.

(2) For application for registration with Vehicle Inspection by three itemized test categories
 
A registration fee, testing handling charges and verification test fee and testing report fee will be necessary.
See the price table on the Council’s website.

 

Q27: What are the fees for a certification inspection of testing equipment and facilities?
A27:  The facility/equipment inspection fees are different in Japan and overseas. In addition, there are transportation fees (actual expenses), and accommodation fees. In addition, if conducted abroad, daily allowances for inspectors will also be required. Also, approval certificate fees and approval tablet costs (for each piece of testing equipment) are also required.


In the case where an inspection is conducted abroad and taxes or any further fees or commissions are incurred accordingly, all such extra costs are to be added to the above-mentioned total.

See the price chart on the Council’s website.


Q28: When applying to register a representative model, how much does it cost to add two insets at once for the same model?
A28: Fees for two cases of registration by category would be required.
See the price chart on the Council’s website


Q29: After registering a representative model, can we register additional sizes for just the cost of the registration fee?
A29: Since this case is to be handled as an additional registration by category, a fee would only be required for a registration by category.

However, in the case of trying to add a model in a size that exceeds the applicable test load value or rotation bending moment value of the registered representative model, or with a rim width that exceeds that of the category representative model, a new registration will be required.

See the price chart on the Council’s website
 

Regarding protection of personal information
Copyright©2019 JWTC All Rights Reserved.